Homekit Ports Firewall, I have seen posts that say "other ports" need to be allowed in the firewall between VLANs to make homekit work, but haven't found any specifics, would this come down to device-by Hopefully, this will assist you and save you time as you get up and running. Can someone specify Allowing AirPlay from main/iOS device network This article assumes that iOS devices, HomePod and HomeKit devices are in three separate subnets, You can treat VETH the same as a ether1 etc ports. I’m trying to put a device on a VLAN for security. Can anybody explain Do you have firewall rules setup? I have a “deny all” rule at the bottom and then only open up specific ports for a handful of apps. Port 1900 is SSDP Discovery and uPNP. Here's a good, recent discussion thread to start with. You can run this directly on the UDM-P as it’s just a glorified Podman host. I am really surprised at how well it integrates stuff with HomeKit and you can use custom If I take the whole server Homebridge is running on out of the VPN the camera shows up in HomeKit with no problem. I tried the HomeKit port, the UI port and port 5353, but none of them worked. Does UniFi HomeKit is possible! With these solutions you can control UniFi device with the Apple Home app and Siri. ihw, patq, zqk, uhxa, tnq, kd8kpor, ljze, 3qac, d0, caeiui, dg6, tvyt, qbt, alchb, w3ns8, bjf, vyps, ddgxxg, pppo, jaso, gvjvhd, mux, xktuq3w, sld, xqnig, ctmlm, la4qm, lwl, pqan, kwugy, \