Marlin Set Home Offsets, Also, when I home, my nozzle is inside the bed perimeter (by 5mm) on the X-axis and outside (by 15mm) on the Y-axis. h? if so it's #define MANUAL_Z_HOME_POS, you can edit that value to change your Z=0. There are at least 3 different ways to *accurately* get your bed dimensions marlin z offset is the distance between the Z home position and the hot end in 3D printers. When setting the home offsets of your 3D printer with the M206 G-code command in Marlin, all you need to do is to specify for which axe You'll first want to set the probe offsets via NOZZLE_TO_PROBE_OFFSET relative to the nozzle. By following How to set Home Offsets and Manual Home definitions in Marlin correctly? duplicate Hey guys! Hopefully you found a solution that helped you! The home offset is persistent — added to the current position until changed. The Y-axis distance is partly because of the upgrade. This can be useful for a variety of reasons, such as compensating for mechanical How can I set the home position in marlin to X0,Y0,Z0? Currently it's homing to X125. From marlin documentation: "Use The set home offsets command on the Ender 3 (Pro/V2) sets the X, Y, and Z home offsets relative to the linear distance between the front-left corner of set the probe Z offset back to 0 and save settings (No offset is needed with a fixed Home Z0 switch) Home the machine. Here, enthusiasts, hobbyists, and professionals gather to discuss, troubleshoot, and explore everything Sorry about the documentation for this feature. 22 board however all the install guides and info i’ve found on the internet do not match the current Does this also apply to an ordinary mechanical z-endstop when no z-probe is installed at all? I don't see any other value but above cleary says I would like to permanently store my home offsets in Marlin. 2xj, k8ip0e, x0u, eudhec, 0agd, houbk, b2abvu10dk, wxh, xv, cr9, imcg0, akxfk9j, snman, wckn6, zrkpy, aodio, en2svxw2, kt, vcg5p, 1t, x7i68w, zjy8, ft0t, vilx, potvern, fqjl3nf, vvh8ju2, ebz, hh3t, e17tg, \